Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.3. Calibrationmode
The calibration must be carried out once. It must be carried out at a standstill and with the battery pack inserted. It
is called up automatically on the first start. If the e-bike does not have a speedometer, calibration is not required.
The calibration consists of two sections. First a rough calibration, then a fine one. In the first section of the
calibration, an increasing speed is output on the speedometer. Switch off the e-bike as precisely as possible at 10.0
and wait at least 5 seconds. After switching on again, the fine calibration is carried out. A speed is output on the
speedometer, which gradually approaches 10.0
As soon as 10.0
is displayed for the first time (it can take several minutes), switch off the e-bike again and wait at
least 5 seconds.
Carrying out calibration at first start-up:
1.
Switch on the e-bike → [Display shows slowly increasing speed, calibration level 1]
2.
Switch off e-bike at approx. 10.0
3.
Switch on the e-bike → [Display shows slowly increasing speed and keeps
dropping towards 0
4.
Switch off e-bike at exactly 10.0
Start the calibration again manually:
1.
Switch on e-bike → [Display stays at 0.0
2.
Switch off the e-bike after it has booted up completely, wait 5 seconds
3.
Switch on e-bike → [Display shows 10.0
tuningmode]
4.
Switch off the e-bike after 10.0
5.
Switch on the e-bike → [CalibraQon level 1]
in small steps and, in the meantime, briefly drops towards 0.0
, wait 5 seconds
, calibration level 2]
, wait 5 seconds
, 1:1 mode]
with correct calibration (otherwise a different constant value),
or another constant value is displayed, wait 5 seconds
.
Werbung
