Cleaning And Care - Elica Wizard Montage- Und Gebrauchsanweisung

Cleaning and care

Cleaning the surfaces
Danger due to electric shock! Discon-
nect the extractor hood from the power
supply by pulling the plug out of the
socket or by switching off the fuse.
When cleaning, make sure that no water
penetrates the device.
Regular cleaning of the surface saves
laborious removal of stubborn contami-
nation. Only use conventional deter-
gents or universal cleaning agents suit-
able for cleaning stainless steel/
aluminium. Never use abrasive cleaning
agents or steel wool. After cleaning the
hood, treat the stainless steel surfaces
with a stainless steel care product.
Painted surfaces should only be cleaned
using a mild detergent solution and a
very soft cloth. Only use a soft damp
cloth to clean the operating panel.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are not due to a malfunction of the hood.
Please clean the panel underneath the
filter regularly to prevent the formation of
stubborn residues.
Cleaning and care instructions
When cleaning the grease filters, also
remove any grease deposits from the
accessible housing components. This
will prevent a fire hazard and maintain
an optimum range of functions. Use hot
soapy water or a mild window cleaning
agent to clean the hood. Do not scratch
off baked-on deposits. Soften them us-
ing a damp cloth. Do not use abrasive
agents or scouring pads.
Note: Do not use alcohol (spirits) on
plastic surfaces, as dull spots may re-
sult.
Caution: Ventilate the kitchen suffi-
ciently, no open flame.
Only clean the operating panel with a
soft damp cloth (mild detergent solu-
tion). Do not use stainless steel cleaners
for the sliding switch/pressure switch.
Operating Instructions
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean
stainless steel surfaces with abrasive
scouring pads or with cleaning agents
containing sand, soda, acid or chloride!
Clean in direction of polish only.
We recommend our stainless steel
cleaner no. 461731. See the enclosed
service booklet for the order address.
Aluminium, varnished and plastic
surfaces:
Use a soft microfibre cloth. Do not use
dry cloths. Use a mild window-cleaning
agent. Do not use aggressive cleaning
agents or agents containing acid or lye!
Do not use scouring agents.
Metal filter changing
Removing filters
Fire hazard! The performance of the
extractor hood is reduced by grease
residues and the fire hazard increases.
The metal filter must be cleaned regu-
larly to prevent a fire hazard. The grease
filters must be cleaned at least once a
fortnight. To do this, turn the metal filter
to the left from the operating side until
the bayonet fitting opens. Pull the filter
downwards to remove it. The filter is
fitted in the reverse order. When fitting
the filter, ensure that F = front side!
en
39