Soba Babynova 1000 Bedienungsanleitung Seite 37

The main switch also serves as door opener.
To open the door turn the main switch to the position "
Through the pulse function with automatically release the main switch returns afterwards to the
position " ". For reasons of safety the door can only be opened about one minute after finishing
of program.
After each wash or drying cycle the main switch should be set to the position "
Programs that wash for a long time and at lower temperatures are usually the most effective In
terms of energy consumption.
The spin speed has an impact on noise emissions and residual moisture: the higher the spin speed
in the spin cycle, the higher the noise emissions and the lower the residual moisture.
Prior to the first wash
The washing machine must be properly installed and connected.
The washing machine was tested before leaving the factory. To make sure that any traces of water
used in the test are removed, wash for the first time without introducing any dirty linen.
•
do not put any dirty linen into the machine
•
open the water cock
•
place 1/2 measuring cup of detergent in the chamber foreseen for the main detergent (see
page 39)
•
start the „easy-care / fi ne wash" programme at 60°C and let it run its course
The washing machine is now clean and ready for operation.
Main switch
The main switch allows you to choose between the following settings.
„ " - ON with Spin Dry - spinning at 1000 rpm (final spin speed).
„ " - ON without Spin Dry
".
37
".