Soba Babynova 1000 Bedienungsanleitung Seite 35

Connection and installation
Open the loading door
•
connect machine to electricity supply
•
turn the main switch to position "
Water inlet connection
•
It is intended for cold-water connection only.
•
Screw the intake hose on to the tap.
•
The washing machine is intended for a water pressure of 1 to 10 bars. If the pressure
exceeds 10 bars, a pressure reducing valve must be installed in the water-line. If the
pressure is less than 1 bar, the flow rate regulator behind the strainer (in the water inlet
connection of the machine) must be removed.
•
Check if all hose's connections are leak tight!
Drain connection
•
Do not kink the drain hose.
•
Hang the drain hose over the edge of the sink or wash basin. The
bend in the hose must not be raised more than 1 m above the
surface on which your machine stands (so that drainage can
function properly).
•
Secure the drain hose with the hose holder supplied.
Pull the hose holder to the center of the hose bend onto the drain
hose and secure against slipping. If required, use a weight or any
other suitable means to ensure that the drain hose cannot slip.
•
Tight connection to a non-ventilated drain requires special steps
and should carried out by a plumber only.
Setting up and starting
•
Ensure the unit is on an even, firm surface.
•
All four screw-mounting feet must stand firmly on the floor.
•
To set up the machine, adjust one or more of the screw-mounting
feet by loosening the counter-nuts.
•
After adjusting the screw-adjustment feet, tighten the relative lock
nuts again in the direction of the arrows (with a SW 17 spanner).
•
Turn on the tap and check the run off hose.
•
Always ensure the drain hose is free of obstructions of any kind, since this will have an
adverse effect on the smooth running of your machine.
•
Only install your machine in a room protected from frost.
•
The company except no responsibility for improper use, or maintenance work carried out by
unauthorized service personnel resulting in water damage.
" .
35