Ohmex ROB 4600 Gebrauchsanleitung Seite 53

ROB 4600
Cleaning / Changing the Side Brushes
If the side brushes are dirty, you can clean them with clear
water. Do not use any additional cleaning agents.
If the side brushes are used up or defective, replace them
with new ones.
1. Turn the appliance around.
2. You can simply pull the side brushes upwards.
• Clean any hair or other dirt from the side brush. When
putting the side brushes on, pay attention to the
markings (R) and (L). The side brushes must engage
with a "click".
Cleaning the Floor Brush
The floor brush can be removed for easy cleaning.
1. Remove the cover by pressing
the latches (a) and pulling the
cover upwards at the same
time.
2. Pull the floor brush, on the
side with the rubber bearing,
upwards out of the appliance.
- Make sure that the attached
rubber bearing is not lost in
the process.
3. Clean any hair or other dirt from the floor brush.
4. Put the floor brush back into the appliance.
- Insert the side with the square nose first.
5. Put the cover back on. It should click into place.
Cleaning the Cleaning Fleece
After you have removed the cleaning fleece from the water
tank, you can wash it at 30 °C with a little detergent. Dry the
cleaning fleece hanging on the clothesline. Do not bleach
or iron!
Wash at or below 30 °C
30
Hang to dry
After the cleaning fleece has dried, you can attach it to the
water tank again.
Replacement Parts
For replacement parts, please consult your dealer.
• Clean the appliance as described and let it dry com-
pletely.
• We recommend that you store the appliance in its
original packaging if you do not intend to use it for a long
period of time.
• Always store the appliance out of the reach of children in
a well-ventilated and dry place.
20
Do not iron
Do not bleach
Storage
• The storage temperature should be between 10 °C and
20 °C.
• Rechargeable battery life: Even when switched off, the
rechargeable battery is constantly discharging. If you
do not use the appliance for a long time, recharge the
rechargeable battery at least every 4 to 6 weeks.
Troubleshooting
Problem Possible Cause
The appliance The rechargeable
has no function. battery is empty.
The rechargeable
battery is defective.
Weak suction The rechargeable
power. battery is almost
empty.
The dust container
is full.
The filters are dirty.
The nozzle is
clogged.
The rotating floor
brush is blocked.
The appliance The rechargeable
stops operating. battery is empty.
The recharge- The rechargeable
able battery battery has reached
does not hold a the end of its life.
charge.
Technical Data
Model:...............................................................PC-BSR 3108
Net weight: ....................................................... approx. 2.8 kg
Protection class: ..................................................................
Power Supply Unit
Protection class: ...................................................................
Input: .................................... AC 100 – 240 V, 50 / 60 Hz, 0.4 A
Output:..........................................................DC 19 V, 600 mA
Polarity: ......................................................................
Rechargeable battery: ....................14.4 V, 2600 mAh Li-Ion
Running time: .................................................approx. 2 hours
Charging time: ................................................approx. 6 hours
EN
53
Remedy
Recharge the
rechargeable
battery.
Contact our ser-
vice department
or your dealer.
Recharge the
rechargeable
battery.
Empty the dust
container.
Clean the filters.
Clean the
nozzle.
Clean the floor
brush.
Charge the
rechargeable
battery.
Contact our ser-
vice department
or your dealer.