Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10/12
14. Attach the Label ⑳ to the in-
side of the helmet box.
*Only for Japanese, Korean
and Australian market.
・Align the right edge of the
Label ⑳ with 28mm line to the
right from the center of screw
in the rear of the helmet box.
・Align the lower edge of the
Lebel ⑳ with 10mm line to the
upper from the difference in
the rear of the helmet box.
In case of combination with the Knuckle Cover [57300-148**]
(separately sold), step 15 & 16 below aren't needed.
Refer to installation instructions for the Knuckle Cover.
15. Remove the bar end cap from
RH and LH handle bar end.
16. Install the Balancer ⑱ by us-
ing the Screw ⑲ to RH and
LH handle bar end.
GENUINE SUZUKI ACCESSORIES
Right
28
⑳
Helmet box
Screw
⑱
⑲
Bar end cap
Werbung
