Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TECHNICAL PASSPORT
Warmer drawer
CARING FOR THE
ENVIRONMENT
Disposal of the packing material
 The transport and protective
packing
has
been
materials which are environmentally
friendly for disposal, and should be
recycled.
 Ensure that any plastic wrappings,
bags, etc. are disposed of safely and kept
out of the reach of babies and young
children. Danger of suffocation.
Disposal of your old appliance
Electrical and electronic appliances
often
contain
materials
handled or disposed of incorrectly, could
be potentially hazardous to human
health and to the environment. They
are, however, essential for the correct
functioning of your appliance.
Please do not therefore dispose of it
with your household waste.
Please dispose of it at your local
community waste collection/recycling
centre or contact your dealer for advice.
Please ensure that it presents no
danger to children while being stored
for disposal.
32
selected
from
which, if
Electrical connection without
plug
 The appliance is designed to be
permanently installed with a three-pin
power cord and may only be connected
by a licensed expert in accordance with
the connection diagram.
 Only
a
gualified
who takes the relevat regulations into
account may replace the power cord.
 Do not use multiple pligs, power
strips or extensions. Overloading causes
a risk of fire.
 If the connection is on longer
accessible following installation, an all-
pin isilating switch with a contact gap
of at least 3 mm must be provided.
 Connect the wires of the mains
power cord in accordance with the
following colour coding:
Green and yellow – Earth wire(E)
Blue - Neutral wire (N)
Brown - Live (L)
Electrical connection with plug
 The appliance is fitted with
a plug and must only be connected to
a properly installed earthed socket.
Only a qualified electrician who takes
the approriate regulations into account
may install the socket or replace the
connecting cable. If the plug is no longer
accessible following installation, an all-
pole isolating switch must be present
on the installation side with a contact
gap of at least 3 mm. Contact protection
must be ensured by the installation.
ENGLISH
electrician
Werbung
