Voltage Input - Santec VTC-8112P Bedienungsanleitung

Bedienungsanleitung / User manual
VTC-8100P / VTC-8112P / VTC-8200P / VTC-8212P / VTC-8300WDP / VTC-8312WDP
On the backside of the camera the following is located:
Joystick:

to open the camera setup OSD (press briefly onto the joystick)

to open the LED lights OSD and the G-sensor OSD (press for approx. 5 sec onto the
joystick) (G-Sensor only available for VTC-8200P, VTC-8212P, VTC-8300WDP and
VTC-8312WDP)
LED:

red light is on; indicates that the camera is supplied with power
BNC jack:

video signal output (coax)

1 Vpp at 75 Ohm

Voltage input:

VTC-8100P:
VTC-8112P:
VTC-8200P, VTC-8300WDP:
VTC-8212P, VTC-8312WDP:
Day/night in
Switch contact input. Used for switching between day and night mode via an external switch.
At closed switch, the camera is set to black/white mode. In order to achieve this, the
day/night switching has to be set to "external" in the camera OSD (see OSD adjustments on
page 49).
Day/night out:
Switch contact output (shutter). Maximum capacity is 20 V DC / 0.5 A.
If the day/night switching has been set to "auto" in the camera OSD, the camera switches to
day/night mode by measuring the brightness through the lens (video signal). If the camera is
in black/white mode, the shutter is closed (see OSD adjustment on page 49).
Motion out:
Switch contact output (shutter). Maximum capacity is 20 V DC / 0.5 A.
If the motion detection has been activated in the camera setup OSD and a motion is detected
in the picture, this shutter is closed.
G-sensor out (only for VTC-8200P, VTC-8212P, VTC-8300WDP and VTC-8312WDP):
Switch contact output (shutter). Maximum capacity: 20 V DC / 0.5 A.
If the G-sensor has been activated in the OSD and the LED light is on, this output switch will
be closed for the determined time.
_________________________________________________________________________________
90-240 V AC
12 V DC / 24 V AC
90-240 V AC
12 V DC / 24 V AC
- 45 -