haacon L/K3 Betriebsanleitung Seite 8

1. uSER GROupS
Duties
Operator Operation,
visual inspection
Specialist Assembly, disas-
personnel sembly,
repair, maintenance
Tests
2. NORMAL uSE
The spindle support device L/K3 is designed for mounting on a trailer
vehicle.
It is not a device suitable for operating on its own.
It must not be brought into circulation until it has been established that
the trailer vehicle with the support device complies with the national
regulations for road traffic.
GB
The support device may only be operated in conjunction with the ope-
rating manuals of the tractor and trailer vehicles and the one supplied
with the support device.
Riding with damaged spindle support device is forbidden.
3. SAFETy INSTRucTIONS
The safety regulations set out in the appropriate points in the opera-
ting manual must be observed for operating, servicing, installing and
repairing the support device. The safety regulations for the tractor and
trailer vehicle are also valid.
After its careful installation check the function of the support device.
If it is not used for the purpose for which it is designed, the support
device may constitute considerable potential danger.
Observe the regulations for road traffic and the accident prevention
regulations issued by the professional associations, in particular
z The operating manual for the tractor vehicle
z The operating manual for the trailer vehicle
z DGUV-V 54 "Accident Prevention Regulations for Winches, Lifting
and Towing Equipment"
z DGUV-V 70 "Accident Prevention Regulations for Motor Vehicles"
z DGUV-V 68 "Industrial Trucks"
z DGUV regulations "Motor Vehicles"
Qualifications
Instruction by means of the operat-
ing instructions; Authorised person
Mechanic
Authorised person per TRBS-1203
(Technical expert)
Ask the manufacturer about the device's suitability for other applica-
tions.
– Observe lifting device and load during all movements.
– Do not leave the load suspended without supervision.
– Transport device protected against impacts and shocks, falling over
or toppling.
– Maximum load does not exceed!
– Do not carriage persons.
– People are not allowed to stand neither in, nor on, nor under the
raised load without additional support.
where a failure to observe instructions would result in
special danger, these instructions are marked with the
warning symbol shown here.
4. DELIVERy
1 Set of spindle support device =
1 Support right
1 Support left
1 Crank handle
1 Crank handle holder
1 Connection shaft
2 Sleeves
Model plate L/K3
– 8 –
Order No. for set
Max. dynamic load
Max. static load
Production year