haacon L/K3 Betriebsanleitung Seite 11

8. TESTING
The rear supports must be tested at least once a year by an authorised
person per TRBS 1203 (Technical expert).
Technical experts are persons, who have sufficient knowledge based
on their specialist training and experience, in the areas of winches,
lift and pull systems and the relevant official occupational health and
safety rules, accident prevention regulations, guidelines and generally
accepted engineering rules (e.g. EN standards), to evaluate the op-
erational safety of winches, and lift and pull systems. Technical experts
are to be nominated by the operator of the equipment. Performance
of the annual occupational safety inspection as well as the training
required to obtain the aforementioned knowledge and skills can be
provided by haacon hebetechnik.
9. SERVIcE
Only allow the device to be serviced and repaired by trained personnel.
Only use genuine spare parts for repair work.
Do not make any modifications or additions to parts with a safety
function.
Additional mountings must not adversely affect safety.
The relevant regulations apply.
Test the function after repair.
Cleaning
Clean the support device as part of your normal vehicle care.
Do not spray high pressure cleaner jets direct at
the support device.
Servicing instructions
Servicing work
Grease spindle and spindle nut
Professional inspection accord-
ing to DGUV-V 54
Conduct a visual inspection of
the support device for signs of
cracks an deformation
The spindle support device must be checked by an expert at least
during the normal vehicle inspection routine, particularly for stiffness.
If necessary wear parts are to be replaced. The spindle support device
is filled with durable grease. It must not be connected to the central
lubrication system.
There is a grease nipple on the external tube to grease the spindle.
Depending on the frequency of use and the requirements placed on
the device, the spindle must be greased at regular intervals, at least
biannual.
To do this extend the spindle support device as far as possible and
retract it again as you lubricate it.
If you replace gear parts, spindles or nuts, you must grease the device.
– 11 –
Servicing interval
Biannual
Every year
Each time you use the support
device. Repair the support device
immediately if it is damaged.
GB