Hyundai WS 4380 Bedienungsanleitung Seite 32

7.2.5 Outdoor Temperature Alert Function
• Press ALERT button to select to activate or deactivate outdoor temperature alert
function.
- Press ALERT button select to:
Active outdoor upper temperature alert, the icon
temperature digit would display.
- Active outdoor upper& lower temperature alert, the icon
outdoor temperature digit would display.
- Active outdoor lower temperature alert, the icon
temperature digit would display.
- Deactivate outdoor temperature alert, alert icon disappear.
• Hold ALERT button for 3 seconds to enter outdoor temperature alert setting.
Icon or beside Temperature's digits flash. Press ▼ or ▲ button to adjust
the setting value, press ALERT button to confirm the setting. Setting Sequence
as follow: Upper limit of temperature, Lower limit of Temperature.
• When it's alert, the corresponding icon
flash on the LCD. Press any buttons to stop the alert sound, otherwise, it will
sound for 2 minutes, and stop automatically.
7.2.6 Comfort Indicator Bar for the display of pleasant / unpleasant climate.
7.2.7 The use of 1,5 m cord Temperature Probe
• Insert the probe plug into the jack on the outdoor sensor.
• Put the cable outside and leave the Thermo Sensor Unit indoor to avoid freezing
up the battery when the outdoor temperature is below −20 °C.
• Always use the temperature probe to sense the temperature when the
temperature is between the following range: −50 °C ~ 0 °C and +50 °C ~ +70 °C
8. TIME AND ALARM SETTING
8.1 RADIO CONTROLLED CLOCK
• After batteries inserted and main unit finishes receiving the transmission from
outdoor sensor, the clock automatically starts to scan the DCF time signal.
Radio Control Icon
the icon will be lit. If not, the icon disappears.
• The clock automatically scans the time signal at 3.00 a.m. every day to maintain
accurate timing. If reception fail, scanning stops (
• The clock can be set to scan the time signal manually by holding ▼ and ▲
button for 3 seconds. Each reception takes about 5 minutes. If receptions fail,
scanning stops.
• Stop scanning by holding ▼ and ▲ button for 3 seconds.
• The shown on the LCD if it is in daylight saving time mode.
8.2 MANUAL TIME SETTING
• Hold MODE button for 3 seconds to enter Clock / Calendar setting mode.
• Press ▲ or ▼ button to adjust the setting and press MODE button to confirm
each setting.
Note: By keeping the ▲ or ▼ button pressed, could accelerate the process and reach the
desired value more quickly.
flashes on the LCD. If the signal is received successfully,
EN - 30
besides outdoor
besides outdoor
or and temperature digit would
on LCD disappear).
/ besides