Entering Codes; Power Supply; Summary - Simons Voss Technologies PegaSys Teach-in Serie Kurzanleitung

17 / 48 | EN
All terminals are delivered with the same programming
code and the same default settings (see
function and programming [} 18]
change the programming code immediately.

1.5. Entering codes

Press the * key to finish entering a code. Press # to delete
the last input. If no key is pressed for 20 seconds during in-
put, the terminal switches off again.

1.6. Power supply

An audible signal is emitted if the battery is almost empty. If
the battery is completely discharged, a red light will flash
every two seconds.

1.7. Summary

Number of possible operator
codes
Number of digits in an oper-
ator code
Number of digits in a pro-
gramming code
Code types, their
). You thus need to
126
3 – 8 digits
5 – 8 digits
1. Introduction