Instar IN-8415 2K+ Bedienungsanleitung Seite 23

01 - Photosensor
02 - Lens
03 - Infrared LEDs
04 - Status LEDs
05 - PIR Detector
06 - Loudspeaker
07 - MicroSD Card Slot
08 - Microphone
09 - Power Connector
10 - WPS / Reset
11 - Alarm In/Out
12 - Antenna Connector
13 - Network Port
14 - Audio Output
15 - Mount
16 - Camera Label
4.3. Status LEDs
Status LED
Constant on
Slow Flashing
Fast Flashing
Off
Go to https://install.instar.com
Twilight switch for IR LEDs
Wide-angle (focal length: 4.3mm / field of view: ~ 90º dia.)
10 IR LEDs (nightvision @ 850nm)
Red: power; blue: network status (Please refer to Section 4.3)
Integrated passive infrared motion detector
Integrated loudspeaker
Slot for MicroSD/SDXC cards (max. 256GB)
- 32GB included inside the camera -
For noise detection / audio rec. / two-way audio intercom
5V / 2A DC - Plug Ø : 1.35mm (in) / 3.5mm (out)
Three seconds for WPS WiFi setup / 20 seconds for reset
Input for potential free external alarm sensors
Output (relay) can support max. 24V/1A
RP-SMA WiFi antenna connector (not for PoE version)
RJ45 LAN port / connector for Cat5e LAN cable or higher
3.5mm jack for earphone / active speaker
Standard camera thread for included stand (1/4"-20 UNC)
P2P ID, LAN MAC address and serial number
Blue LED
Connected to WiFi
Connecting via WPS
No connection to WiFi
LED is turned off, or camera
is not plugged into power
Red LED
N/A
Camera at work
Upgrading firmware
LED is turned off, or camera
is not plugged into power
6-EN