Restoring The Factory Settings Of The Sensor; Assembly - Becker CentronicPLUS SC811 PLUS Montage- Und Betriebsanleitung

Restoring the factory settings of the sensor

10s
In order to ensure the correct functioning of the sensor,
the sensor surfaces must not be covered.
26 - en
Press the programming button and the function/control button for
10 seconds.
▻ The indicator lamp flashes red. Once the data has been
deleted, the indicator lamp will flash green twice, and the
device will reboot.
► When the indicator lamp has gone out, the radio receiver has
been reset to the factory settings.

Assembly

• Check that the transmitter and re-
ceiver are functioning perfectly prior
to installation in the desired location.
• Fix the sensor to the wall using the
three enclosed screws.