Programming The Remote Control - Becker SensorControl SC711A Montageanleitung Und Betriebsanleitung

Programming the remote control

Note
Before the SC711A can be programmed, a master transmitter (e.g.
SWC241A) has to be programmed into the radio receiver for sun pro-
tection systems, and the limit stops have to be programmed.
Caution
Before programming the master transmitter, always ensure that there
are no obstructions in the immediate operating area of the sun protec-
tion system, as the system may extend unexpectedly.
Programming the SC711A
The SC711A features an integrated radio transmitter.
a) Press the programming pushbutton of the master transmitter until acknowl-
edgement is given by the receiver.
b) Press the programming pushbutton on the SC711A until the receiver confirms
the signal setting.
c) Now press the programming pushbutton on the new SC711A to be pro-
grammed once more.
The receiver will indicate when the learn process has been successfully com-
pleted.
The maximum radio range is up to 15 m indoors and up to 150 m in the open.
de
en
15