Specifications; Problems & Solutions - Peach PB200-09 Handbuch

GB
Specifications
Item no.:
Max. punching capacity/time:
Max. binding capacity/time:
Paper margin:
Hole distance:
Hole qty.:
Max. punching width:
Net weight of machine:
Size of machine:
Problems & Solutions
Problems
1. The lever couldn't be pressed
down when punching
2. Slanting paper margin
3. Slanting plastic comb open
4. Paper punching is not
complete and it's hard to pull
out the paper
5. Paper couldn't touch the rack
when inserting
8
00510694
4 sheets
50 sheets / 12mm plastic comb
2.5mm(square holes); 6.25mm (round holes)
14.3mm(square holes); 80mm (round holes)
21 square holes, 4 round holes
303mm(front); 335mm (back)
1.23kg
436*148*80mm
Reasons
Paper scraps or other hard materi-
als stay inside the paper cutter
Exceeding the punching capacity Operate according to the manual
The paper is lopsided when inserting Take out the paper and put in again
Paper scraps or other hard materi-
als stay inside the paper cutter
The binding mechanism is
distorted
The comb opening hook is
distorted
Exceeding the max. Punching
capacity
The paper is old with the side
rolling up
Solutions
Clean up the rubbish with hard-
board
Clean up the rubbish
with hardboard
Adjust the binding teeth on the
rack
Press open the comb opening
mechanism and just the hook
Lessen the punching
thickness ( follow the manual)
Smooth the paper and insert
again