Machine Structure; Maintenance - Peach PB200-09 Handbuch

Mobile paper punch-
and bindingmachine

Machine Structure

1 press punching cover
2 left/right binging handle
3 paper fixed guide line (4 holes)
4 paper fixed guide line (21 holes)
5 support rack
6 bottom-1
7 comb opening mechanism
8 waste tray (on the bottom of the machine)
Cautions
1. Take out the machines and its affiliated parts,
then place the machine onto a secure and even
table to avoid it falling over and causing damage
to people or the machine itself.
2. Operate the machine according to the instructions
to punch paper and document covers.
3. Pls test the machine with some unofficial docu-
ments when punching the official documents.
4. We suggest to put the plastic cover between
two sheets of paper before punching it.
Punching
a. Insert the paper or cover into the punching slot
until it touches the back of the slot, then adjust
the positioning as per the paper fixed guide line 4 ,
and then press downwards the punching
cover 1 until the blade stops (21/3*8 hole
punching) A
b. Insert into the paper or cover from the back
and adjust the positioning of the paper as per
the paper fixed guide line 3 , and then press
downwards the punching cover 1 until the
blade stops (4/5.5 round hole punching) B
c. Max. punching capacity for paper is 4 sheets
(80gsm / A4). In order not to cause paper jam
and excessive damage to the machine, we sug-
gest not to punch more than 2 sheets of plastic
covers at one time.
d. Max. punching width in the front is 303 mm,
and 335 mm at the back.
e. Lift the press punching cover, then move away
the punched documents.
Binding
a. Choose the proper size of comb as per the
thickness of the documents, then locate the
comb onto the comb plate and the comb
opening mechanism 7 ; and open the comb to
proper width by turning upwards the binding
handles 2 C.
b. Locate the punched documents onto the open
comb, then turning downwards the binding
handles to close the comb. Then take out the
bound documents.
c. Choose the comb according to the thickness
of the document. The following form is for your
reference to choose the proper comb.
Comb size (mm) (inch)
6 1/4
8 5/16
10 3/8
12 1/2
Clean up the waste tray
Pull out the waste tray 8 , then pour over the paper
waste then install it back. Pls clean the waste tray
frequently to better results.

Maintenance

1. It is forbidden to use gasoline to clean the
surface of the machine! Pls use a cloth with
some detergent to clean it.
2. Don't punch more paper than the indicated
max. punching capacity! Otherwise, the
machine will be damaged.
3. Don't place the machine in a wet place!
GB
Binding sheets
1-12
13-20
21-35
36-50
7