Electrolux UG0985RE Benutzerinformation Seite 15

Problem
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
The melting water outlet is
not connected to the evap‐
orative tray below the ap‐
pliance.
The FastFreeze function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
ENGLISH
Solution
Wrap the food products
better.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
Set a higher temperature.
Refer to "Control panel"
chapter.
Attach the melting water
outlet to the evaporative
tray.
Switch off FastFreeze
function manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"FastFreeze function" sec‐
tion.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
15