Zodiac Genius Installations- Und Bedienungsanleitung Seite 8

❸ Use
3.1 I Operating principle
The cleaner is separate from the filtration system and can function independently. It simply needs connecting to the
mains.
It finds the best route to move around and clean the areas of the pool for which it has been designed (depending on the
model: floor only, floor and walls). Debris is sucked in and stored in the cleaner's filter.
The control box is used to remotely control your cleaner and provide initial diagnostics indicators.
3.2 I Pool preparation
• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The appliance must operate in pool water with the following properties:
Water temperature
Chlorine
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to optimise the
appliance's performances.
• Remove any thermometers, toys and other objects that might damage the appliance.
3.3 I Immersing the cleaner
• Place as much of the floating cable as possible in the water.
• Place the cleaner into the water using the handle (see figure
• Move it slightly in all directions so that the air contained in the cleaner escapes (see figure
• It is essential that the appliance sinks on its own and settles on the pool floor (see figure
pH
Between 15°C and 35°C
Between 6.8 and 7.6
< 3 mg/ l
).
EN
).
)..
7