tbs electronics Omnicharge Solar OCS 150-60 Bedienungsanleitung Seite 23

Charge current is too low
Batteries are not fully
charged
Batteries are overcharged
Battery is full
Incorrect battery settings
Insufficient solar power
Charger operates too hot
Battery load current is
higher than the charger's
output current
Incorrect battery settings
DC cables too thin
Insufficient solar power
Nominal Battery Voltage
setting too high
Battery Charge Voltage
setting too high
23
If the battery is full the
charger will stop charging or
will greatly reduce the
charge current.
Check if the Nominal Battery
Voltage corresponds to the
actual used battery. Error
code E1 or E2 is shown on
the display.
Make sure that the solar
panels are exposed to
sufficient sunlight. Check if
the solar panel array is sized
correctly in terms of power.
When the charger is too hot,
the charge current will be
reduced automatically.
Please check the charger's
mounting location and make
sure of sufficient cooling. E6
is shown on the display.
If you wish to fully charge
the battery, please reduce
the DC loads connected to
the battery.
Check if the Charge Voltage
(bulk/absorption) is not set
too low for the used
battery.
Install larger DC cables. See
the DC cable size table in
chapter 2.3 of the
installation manual.
Make sure that the solar
panels are exposed to
sufficient sunlight. Check if
the solar panel array is sized
correctly in terms of power.
Check if the Nominal Battery
Voltage corresponds to the
actual used battery.
Please if all battery charge
voltages are set correctly
(Charge Voltage as well as
Float voltage if applicable)