tbs electronics Omnicharge Solar OCS 150-60 Bedienungsanleitung Seite 22

4. TROUBLESHOOTING GUIDELINE
4.1 Troubleshooting table
Please see the table below if you experience any problems with the Omnicharge Solar charger
and/or the installation.
Problem
Omnicharge Solar charger is
not working at all (no LEDs
and display).
Charger seems to be
powered (battery indicator
LEDs are on) but does not
charge
Possible cause
Battery and/or solar panel
incorrectly connected
Battery fuse blown or solar
panel switch turned off
Charger damaged
No solar light
Incorrectly connected solar
panel
Solar panel voltage too low
Solar panel voltage too high
22
Remedy
Please check if the polarities
of the battery or solar panel
connection are correct
Check any fuses and/or DC
switches in the battery and
solar panel wiring. Measure
the voltage at the battery
and solar inputs of the
charger for correct values.
Please contact your TBS
dealer for further assistance
Please make sure that the
solar panels are not covered
and exposed to sufficient
sunlight. Night icon is
showing in display.
Please check solar panel
wiring to the charger and
make sure that there are no
fuses blown or DC switches
opened and that the
polarity is correct.
Make sure that the solar
panels are generating a
voltage that is at least 2V
higher than the current
battery voltage. Check input
terminals of the charger.
Please check if the solar
panel is not exceeding the
maximum input voltage of
the charger. If it does,
disconnect immediately and
revise the installation.