Initial Use; Switching On; Setting The Temperature; Automatic Switch-Off - Sanitas SFW 10 Gebrauchsanweisung

4.2 Initial use

Insert the mains plug into the socket.

4.3 switching on

To switch the foot warmer on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings (4) are illuminated when switched on.

4.4 setting the temperature

Level 0: OFF
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
NOte:
The fastest way to warm up the foot warmer is to initially set the highest temperature setting.
NOte:
This foot warmer has a fast heating function, which allows the foot warmer to warm up
faster in the first 10 minutes.
WARNING
If the foot warmer is being used over several hours, we recommend that
you set the lowest temperature setting on the controller to avoid over-
heating the feet, which may lead to burns to the skin.

4.5 Automatic switch-off

This foot warmer is equipped with an automatic switch-off function. This turns off the heat sup-
ply approx. 90 minutes after the initial use of the foot warmer. The temperature setting display
then starts to flash. So that the foot warmer can be switched back on, the sliding switch for ON/
OFF and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds
it is possible to switch it on again.

4.6 switching off

To switch the foot warmer off, set the sliding switch for ON/OFF and temperature settings to setting "0" (OFF).
The temperature settings are then no longer illuminated.
NOte:
If the foot warmer is not in use, switch the sliding switch for ON/OFF and temperature settings to
setting "0" (OFF) and unplug the mains plug from the socket.

5. cleaning and maintenance

WARNING
Before cleaning, always remove the mains plug from the socket first.
Otherwise there is a risk of electric shock.
11
90
min
STOP