Werbung
Verfügbare Sprachen
Verfügbare Sprachen
dig along the incline (not up and down). For
safety reasons, the Electric Tiller may not be
used to dig up inclines whose
gradient exceeds 15 degrees. Use special
caution when backing up and pulling the
implement (tripping hazard)!
Tips for proper working
Always guide the machine slowly and wisely
forward.
Dig up the area in straight lines. Let the tracks
overlap slightly to not miss any stripes to dig.
Only use the machine to dig up already
loosened soil.
Transport and storage (fig. 10, 12)
Always pull out the power cord before
transporting!
The electrical motor installed is connected
and ready for operation. The connection
complies with the applicable VDE and DIN
provisions.
The customer's mains connection as
well as the extension cable used must also
comply with these regulations.
Damaged electrical connection cable
The insulation on electrical connection cables
is often damaged.
This may have the following causes:
• Passage points, where connection cables
are passed through windows or doors.
• Kinks where the connection cable has been
improperly fastened or routed.
• Places where the connection cables have
been cut due to being driven over.
• Insulation damage due to being ripped out of
the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables
must not be used and are life-threatening due
to the insulation damage.
Check the electrical connection cables for
damage regularly. Make sure that the
ELECTRICAL CONNECTION
Pull the lock pin (17). You can now move the
wheels (7) to the lower position. Make sure
that the lock pin (17) engages again in the
lower position. (fig. 10)m Attention! The
wheels must be fixed in the upper position
during operation!
For storage or transport in a limited space,
proceed as follows:
Open the wing nuts (10) until you can fold the
handles
forward. Attention! Danger of crushing your
fingers.
Now you can transport your machine with the
transport handle (3).
So you can storage the machine too.
connection cable does not hang on the power
network during the inspection.
Electrical connection cables must comply with
the applicable VDE and DIN provisions. Only
use connection cables with the marking
„H05VV-F".
The printing of the type designation on the
connection cable is mandatory.
AC motor
• The mains voltage must be ~230-240 V / 50
Hz • Extension cables up to 25 m in length
must have a cross section of at least 1,5 mm² ,
above 25 m at least 2,5 mm²
• The mains connection is protected with a
16 A slow-blow fuse.
Connections and repairs of electrical
equipment may only be carried out by an
electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
52
Werbung
