Werbung
Verfügbare Sprachen
Verfügbare Sprachen
after having drunk alcohol or taken
medicine. Always take a work break in due
time. Approach the work with common sense.
• Familiarize yourself with the terrain and
remain focused on the potential hazards that
you could miss on account of the motor noise.
• Always maintain a secure footing while
working, especially on a sloping never up
and down! Be particularly careful when
changing the travelling direction. Do not work
on very steep slopes.
• Always guide the implement at a walking
pace with both hands on the handle. Be
especially careful when you turn the
implement around or draw it towards you.
Danger of stumbling!
• Start or actuate the starting lever with care
and in conformity with the directions in these
Instructions.
• Do not tilt the implement when starting, other
than it has to be lifted. In this case tilt the
implement only to the extent that is absolutely
necessary and always lift the implement on the
side that is opposite to the operator.
• Do not operate the implement in the vicinity
of inflammable liquids or gases as this could
give rise to the danger of a fire or explosion.
Work intervals:
• After the implement has been turned off, the
cutting cylinder will continue to rotate for a few
seconds.
Keep hands and feet well away.
• Only shift working depth when the
implement is completely stillstanding.
• Only remove plant parts and soil when the
implement is standing completely still.
• Switch off the power when the implement is
to be transported, lifted or tilted and when
traversing other surfaces than soil.
• Never leave the implement unattended at
the place of work.
• Always switch off the implement and
disconnect the power plug:
- Whenever you leave the implement
- Before you clean the ejector opening or
unblock or unclog the implement
- When the implement is not being used
- During all maintenance and cleaning work
- When the power cable is damaged or has
become tangled
- When the implement hits an obstruction
during work or when unusual vibrations arise.
Establish the cause and see if the implement
has been damaged.
• Do not repair it yourself! Have the implement
repaired by an authorised workshop!
• Store the implement in a dry place well out
of reach of children.
CAUTION! The following states how to avoid
damage to the implement and any resulting
harm to people:
Take care of your implement
• Switch off the power when the implement is
to be carried across steps.
• Inspect the implement each time before it is
to be used. Never operate the implement if
safety devices (e.g. impact protector, parts
of the cutting facility or bolts are missing,
worn out or damaged.
Check especially the power cable and starting
lever for damage. To avoid imbalance, all tools
and bolts must be exchanged as complete
sets.
• Only use spare parts and accessories that
have been supplied or recommended by the
manufacturer. The use of alien parts results in
the immediate loss of all guarantee claims.
Ensure that all nuts, bolts and screws are
firmly tightened and that the implement is in a
safe working state.
• Never try to repair the implement yourself,
other than you have been trained accordingly.
All work that has not been listed in these
Instructions must only be carried out by
authorised servicing agencies.
• Treat the implement with the greatest care.
Always keep the tool clean for better and safer
work. Follow the maintenance instructions.
• Never overload the implement. Always work
within the specified capacity range. Do not use
low-power machines for heavy-duty work. Do
not operate the implement for purposes for
which it is not intended.
Electrical safety:
CAUTION! The following states how to avoid
accidents and injuries due to electric shock:
• Before each use, carry out a visual
inspection of the power and extension cables
for signs of damage or ageing.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent of the
same or a similarly qualified person in order to
prevent hazards.
• Keep the power cable well away from the
cutting tools. Should the power cable become
damaged during work, then instantly
disconnect the power cable from the mains.
49
Werbung
