Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The declared vibration total value
has been measured in accordance with a
standard test method and may be used for
comparing one tool with another that the
declared vibration total value may also be
used in a preliminary assessment of
exposure.
BEFORE STARTING THE EQUIPMENT
Before you connect the equipment to the
mains supply make sure that the data on the
rating plate are identical to the mains data.
Warning!
Always pull the power plug before
making adjustments to the equipment.
The Electric Tiller is delivered
unassembled. The handles and the driving
device must be assembled and mounted
before using the Electric Tiller. Follow
the operating instructions step-by-step and
use the pictures provided as a visual guide to
easily assemble the machine.
Montage (fig. 3-9)
Important!
You must fully assemble the appliance
before using it for the first time!
• Connect the bar (3) and the handle (1) to the
lower bars (4) using the wing nut (9) and lock
screw (8). (fig. 3, 4)
Start and stop the implement (fig. 7)
To prevent an accidental start-up of the
implement, the throttle handle (1) is equipped
with a safety release switch (12) which must
be pressed before the On/Off switch (13)
can be pressed. If the On/Off switch (13) is
released, the equipment switches off.
Repeat this process several times so that
you are sure that the machine functions
properly. Before you perform any repair or
maintenance work on the machine, ensure
emission during actual use of the power
tool can differ from the declared total value
depending on the ways in which the tool is
used and of the need to identify safety
measures to protect the operator that are
based on an estimation of exposure in the
actual conditions of use (taking account of
all parts of the operating cycle such as the
times when the tool is switched off and
when it is running idle in addition to the
trigger time).
Laying the power cord (fig. 5, 6)
Mount the cable and the cable guide (11) on
the lower right bar (4) and (in the working
direction) bar (3) by pushing them on.
Install the transport aid (fig. 8, 9)
Remove the pre-assembled split pin (16)
and the washer (15). Place the wheel (7) on
the wheel holder (14). Secure it with the
washer (15) and the split pin (16). Then
mount the wheel cap (8). (Assembly is
identical on both sides)
Blade roller installing / uninstalling (fig. 11)
Push the blade roller (6) on the drive shaft (20)
of the machine. The blade roller (6) can be
mounted left or right side. Be sure that the
holes of the blade roller (6) and the drive shaft
(20) are aligned.
Now the M8 screw (18) is pushed through
and secured with the M8 locking nut (19).
Tighten the lock nut (19) hand-tight using
a fork wrench or ratchet with socket (the
tools are not included).
For uninstall: Proceed in reverse order
OPERATION
that the cutting unit is not rotating and that the
power supply is disconnected. Always ensure
that a safe distance (provided by the long
handles) is maintained between the user and
the housing.
The safety distance between housing and user
given by the handle (1) must always be
observed. Be especially careful when digging
and changing direction on slopes and inclines.
Maintain a solid footing and wear sturdy,
non-slip footwear and long trousers. Always
A warning that the vibration
51
Werbung
