Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Usability
The SIPLUS Mounting Kit ET 200SP can be used for:
•
SIPLUS extreme variants of the ET 200SP product family
•
SIPLUS BaseUnits with a height ≤ 117 mm type A0/A1, without AUX or additional terminals or types B0, B1, C0, C1, D0
and U0
•
SIPLUS ET 200SP BusAdapter:
BA 2xFC
–
BA 2xSCRJ
–
BA 2xLC
–
The following devices are not approved for use with the SIPLUS Mounting Kit ET 200SP:
•
ET 200SP BusAdapter BA RJ45
•
ET 200SP digital output module F-RQ 1x24VDC/24..230VAC/5A
•
ET 200SP motor starters
•
SIPLUS ET 200SP CM DP 6AG1545-5DA00-2AB0
•
SIPLUS ET 200SP CPU 1510 and CPU 1512 with the article numbers:
6AG1510-1DJ01-7AB0
–
6AG1512-1DK01-7AB0
–
6AG2510-1DJ01-4AB0
–
6AG2512-1DK01-4AB0
–
6AG2512-1SK01-4AB0
–
•
DPP interface not permissible in operation
•
USB interface not permissible in operation
Safety guidelines
WARNING
Dangerous voltages
Voltages > 60 V can be present in the system. There is a danger to life and the risk of serious injuries.
Before starting any work on the system, disconnect the system from the power supply and secure it against being switched
on again.
Correct transport, storage, installation and assembly, as well as careful operation and maintenance, are required to ensure
that the system operates safely and without faults. This system can only be installed and operated in compliance with the
instructions and warnings contained in the relevant technical documentation. Only qualified personnel can install and
commission the system.
6
Mounting Kit ET 200SP
A5E47207185B/003, 07/2021
Werbung
