Installation (only for approved contractors)
▶ Position the water inlet and outlet pipes into the sealing
membrane.
Fig. 29
18
▶ Adjust the hydraulic block until it is firmly secured at the
back of the appliance.
Fig. 30
▶ Place the bonded washers onto the water connections.
▶ Tighten the water connections.
▶ Check if there are leaks.
5.8
The air must be purged from the appliance
After all of the hydraulic connections to the appliance have
been carried out, purge the air from the appliance,
▶ Turn on the cold water supply.
Tronic 4000 – 6721830066 (2021/06)