miniland digimonitor 4.3" pro Bedienungsanleitung Seite 17

PROBLEM
The camera does not turn on.
The camera is not transmitting.
The camera battery cannot be charged.
It is not possible to hear the baby on the
parental unit.
The tunes cannot be heard.
Interference or poor reception.
If the baby unit has lost connection with the
parental unit.
8. TECHNICAL SPECIFICATIONS
Frequency
Operating Range
Nº of configurable channels
Power (parent unit) Input:
Power (parent unit) Output:
Rechargeable battery for sasasmonitor
Rechargeable camera battery
Power (baby unit) Input:
Power (baby unit) Output:
Operating time with battery fully charged (parent unit)
Operating time with battery fully charged (baby unit)
LCD Screen size
POSSIBLE CAUSE
The camera has no battery.
The camera has not been turned on.
Camera: power adapter not plugged in.
VOX mode or standby mode is activated.
The camera has no battery.
The AC/DC adapter is not plugged in.
The volume setting of the parental unit is
too low.
The tunes volume setting is too low.
Other electronic devices may be interfering
with the signal.
The camera and monitor may be too far apart.
The battery charge level may be too low.
The camera or monitor may be too close to
many metal objects.
The camera and monitor may be too far apart.
Camera has no battery.
Connection between the two units is
momentarily lost.
The connection between the two units
is lost.
2.4GHz FHSS
240m (straight line and open space)
2
100-240 V CA - 50/60 Hz
5 V – 1A
3.7V 2000 mAh
3.7V 950 mAh
100-240 V CA - 50/60 Hz
5 V – 1A
Approximately 8 hours
Approximately 4 hours
4.3"
17
SOLUTION
Plug in the power adapter.
Press the on / off button on the camera (I)
and keep pressing for 2 seconds.
Plug in the power adapter.
To view the monitored area continuously,
switch off the VOX mode or power saving
mode on the monitor.
Plug in the power adapter.
Plug in the power adapter.
Set the volume at the highest level. Check
section 5.2.2.
Set the volume to the highest level. See
section 5.2.10.5.
Move them away from the device.
Extend the antenna (15) of the monitor, and
in case it is still out of range move the monitor
closer to the camera.
Plug in the power adapter.
Move them away from the device.
Extend the monitor antenna, and in case it is
still out of range move the monitor closer to
the camera.
Plug in power adapter.
Restore the units by disconnecting them from
the power supply.
Wait about 15 seconds before reconnecting
them.
Allow one minute for the baby unit and the
parent unit to synchronize.
Pair the camera and monitor again.See
section 5.2.10.1.1.
ENGLISH