Bosch Relyy'y BGS31800 Gebrauchsanweisung Seite 40

25*
Fig.
a) Open the lid of the exhaust ilter by pushing and
pulling on the locking tab.
b) Unlock the HEPA ilter and remove it from the ap-
pliance.
c) Tap out the ilter unit and rinse it under running wa-
ter.
Alternatively, the unit can be cleaned in a washing
machine at max. 30 °C using a gentle programme
and the lowest spin speed.
TIP: To protect other laundry items, put the ilter
unit into a laundry bag.
d) Once the HEPA ilter has dried completely (at least
24 hours), insert it back into the appliance and lock
it in place.
= Close the exhaust ilter lid. In doing so, push the >
lock bar upwards until it audibly clicks into place.
Replacing the HEPA ilter
(only for appliances without a washable HEPA ilter)
To ensure that the vacuum cleaner can work at its op-
timum power level, the HEPA ilter should be replaced
after one year.
26*
Fig.
a) Open the lid of the exhaust ilter by pushing and
pulling on the locking tab.
b) Unlock the HEPA ilter and remove it from the ap-
pliance.
c) Dispose of the old HEPA ilter with your household
waste.
d) Insert the new HEPA ilter into the appliance and
lock it in place.
= Close the exhaust ilter lid. In doing so, push the >
lock bar upwards until it audibly clicks into place.
Micro ilter
Cleaning the micro ilter
The micro ilter is designed so that it does not need to
be replaced, provided the appliance is used as inten-
ded in the household.
To ensure that the vacuum cleaner is working at its op-
timum power level, the exhaust ilter should be rinsed
out after one year. The iltering action of the ilter re-
mains intact, even if the ilter surface becomes disco-
loured.
27*
Fig.
a) Open the lid of the exhaust ilter by pushing and
pulling on the locking tab.
b) Pull the locking tab to unlock the ilter unit with foam
ilter and microilter and remove it from the appli-
ance.
c) Remove the foam ilter and microilter from the ilter
frame.
d) Rinse the foam ilter and micro ilter under run-
ning water. Alternatively, they can be cleaned
in the washing machine at max. 30 °C using a
gentle programme and the lowest spin speed.
TIP: To protect other laundry items, put the unit into
a laundry bag.
e) Once the foam ilter and microilter have dried com-
pletely (at least 24 hours), insert them back into the
ilter frame.
f) Insert the ilter unit in the appliance and ensure that
the locking tabs audibly click into place.
g) Close the exhaust ilter lid. In doing so, push the lock
bar upwards until it audibly clicks into place.
Cleaning instructions
Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the va-
cuum cleaner. The vacuum cleaner and plastic acces-
sories can be cleaned with an ordinary plastic cleaner.
!
Caution:
Do not use abrasive materials, glass-cleaning
agents or all-purpose cleaning products. Never im-
merse the vacuum cleaner in water.
Subject to technical modiications.
* Dependent on model
39