Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. MAINTENANCE AND TROUBLESHOO TING
4.1 Periodic Cleaning
A dirty print head or platen may reduce printing quality or cause malfunctions.
Also, if paper dust collects on the sensor's protective sheet, paper cannot be
detected correctly. We recommend cleaning the printer periodically (every 2 to
3 months) as shown below.
1.
Turn off the power.
2.
Pull the cover open lever forward and open the pap er cover.
3.
Wait a few minutes until the print head cools.
4.
Use a cotton swab dampen ed with ethyl alcoh ol to wipe off any dirt and dust that is
on the print head and platen.
5.
Use a cotton swab damp ened with a little water to wipe off the sensor 's protective
sheet.
Make sure there are no water drops on the cotton swab before wiping.
CAUTION
The print head is hot immediately after printing. Do not touch it.
Do not touch the print head with bare hands or metal objects.
Do not use alcohol or cleansers to clean the surface of the sensor's protective sheet.
Doing so may fog the sensor's protective sheet.
Paper scraps may stick to the platen when adhesive labels are full cut depending on
the printer's environment, the diameter of the paper roll, and the quality of the label
backing.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Print head
V10 CONSUMIBLES S.L.
Platen
— 46 —
Sensor's protective sheet
Werbung
