GB
1. Fully unwind the mains cable.
2. Make sure that the iron voltage (see name plate) and the mains voltage match.
3. Fit on a nozzle. You can dry single hair locks by concentrating the fl ow of hot
air with the hairdressing nozzle.
4. Insert the plug into a duly installed 230V/50Hz protective contact socket.
5. Shift the switch on the handle to one of the desired heat/blowing levels:
Level 0:
Level 1:
Level 2:
Switch-off
After use shift the switch to position „0" and pull out the plug. Leave the device to
cool before putting it away!
•
Before cleaning remove the mains lead from the socket.
•
Clean the housing with a soft, dry cloth without additives.
Mains Cable
•
The mains cable should only be wound up loosely.
•
Never tie the cable tightly round the device, as over time this may result in the
cable breaking.
•
Check the mains cable regularly for damage.
Air Intake Grill
Please clean the grill on the air intake side of the hairdryer regularly in order to
avoid excessive temperatures as a result of heat accumulation.
Model: .........................................................................................................HT 2996
Power supply: ....................................................................................... 230 V, 50 Hz
Power consumption: ..................................................................................... 1600 W
Protection class: ..................................................................................................... ΙΙ
30
05-HT 2996 30
Commissioning
off
medium airfl ow and medium temperature
strong airfl ow and high temperature
Cleaning and care
Technical Data
08.09.2005, 9:01:48 Uhr