Makita DVP181 Bedienungsanleitung Seite 8

FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the pump is
switched off and the battery cartridge is removed
before adjusting or checking function on the pump.
Installing or removing battery
cartridge
CAUTION:
Always switch off the pump before
installing or removing of the battery cartridge.
CAUTION:
Hold the pump and the battery
cartridge firmly when installing or removing battery
cartridge. Failure to hold the pump and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the pump and battery cartridge
and a personal injury.
► Fig.2:
1. Red indicator
2. Button
To remove the battery cartridge, slide it from the pump
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place with
a little click. If you can see the red indicator on the upper
side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may accidentally fall out of the pump, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is not
being inserted correctly.
Battery protection system
The pump or battery is equipped with a battery protection
system. This system automatically cuts off power to the
motor to extend battery life.
The pump will automatically stop during operation if the
pump and/or battery are placed under one of the following
conditions:
Overloaded:
The pump or battery is operated in a manner that causes
it to draw an abnormally high current.
In this situation, turn the pump off and stop the application
that caused the pump to become overloaded. Then turn
the pump on to restart.
If the pump does not start, the battery is overheated.
In this situation, let the battery cool before turning the
pump on again.
Low battery voltage:
The remaining battery capacity is too low and the pump
will not operate. In this situation, remove and recharge
the battery.
3. Battery cartridge
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.3:
1. Indicator lamps
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first(far left) indicator lamp will brink when
the battery protection system works.
OPERATION
The pump does not contain oil when newly purchased.
Refer to "Adding oil" and add oil.
WARNING:
condition without oil added will damage the pump.
In addition, the oil tank will become hot and may result
in burns or other accidents.
Adding oil
► Fig.4:
1. Oil fill/Exhaust cap
2. Level line
1. Remove the oil fill/exhaust cap and add the supplied
oil via the filler port.
NOTICE:
Always use Makita genuine oil in order to
maintain pump performance.
2. Add oil until the oil level is between the upper and
lower level lines of the sight glass.
8 ENGLISH
2. Check button
Remaining
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
The battery
may have
malfunctioned.
Operating the pump
3. Sight glass
4. Oil tank
capacity
battery.
in the