Kärcher K 2.16 Bedienungsanleitung Seite 12

Safety Devices
Caution
Safety devices protect the user and must not be
modified or bypassed.
Power switch
The appliance switch prevents unintentional op-
eration of the appliance.
Lock trigger gun
This lock locks the lever of the trigger gun and
prevents the inadvertent start of the appliance.
Overflow valve with pressure switch
The overflow valve prevents the permissible
working pressure from being exceeded.
If the lever on the trigger gun is released the
pressure switch turns off the pump, the high-
pressure jet is stopped. If the lever is pulled the
pump is turned on again.
Prerequisites for the appliance's
Caution
Create stability for the appliance prior to all work
on or with the appliance to prevent accidents or
damage.
–
The stability of the appliance is warranted
when it is placed onto an even surface.
Operation
Scope of delivery
The scope of delivery of your appliance is illustrat-
ed on the packaging. Check the contents of the ap-
pliance for completeness when unpacking.
In the event of missing accessories or any trans-
port damage, please contact your dealer.
Description of the Appliance
These operating instructions describe the maxi-
mum equipment. Depending on the model, there
are differences in the scopes of delivery (see
packaging).
Illustrations on Page 2
1 Coupling element for water connection
2 Connection for water supply with filter
3 High pressure connection
4 Detergent suction hose (with filter)
5 Connection for detergent suction hose
®
6 VELCRO fastener
7 Storage for spray lance
8 Mains cable with mains plug
9 Appliance switch "0/OFF"/ „I/ON"
12
stability
10 Trigger gun
11 Lock trigger gun
12 High pressure hose
13 Clamp for high pressure hose
14 Spray lance with high pressure nozzle
15 Spray lance with Dirtblaster
16 Washing brush
Special accessories
Special accessories expand the possibilities of
using your appliance. Please contact your
KÄRCHER dealer for further information.
Mount loose parts delivered with appliance prior
to start-up.
Illustrations on Page 2
Connect the suction hose for detergent to
the connection.
Illustration
Pull out the clamp for the high-pressure hose
from the trigger gun (e.g. a small screwdriver).
Illustration
Connect high pressure hose to trigger gun.
Push the clamp in until it locks. Check the se-
cure connection by pulling on the high-pres-
sure hose.
Illustration
Fix the VELCRO
According to the applicable regulations,
the appliance must never be used on the
drinking water supply without a system
separator. Use a suitable system sepa-
rator manufactured by KÄRCHER; or, as an alter-
native, a system separator as per EN 12729 Type
BA. Water flowing through a system separator is
considered non-drinkable.
Note: Impurities in the water can damage the high-
pressure pump and accessories. For protection,
the use of the KÄRCHER water filter (optional ac-
cessory, order no. 4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Use a fibre-reinforced water hose (not includ-
ed) with a standard coupling. (Minimum diam-
eter 1/2 inch (13 mm), minimum length 7.5 m).
Screw the coupling element (supplied) to the
water connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
- 5
EN
Before Startup
®
fastener to the appliance.
Water supply