Hendi HND299289 Bedienungsanleitung Seite 7

Cleaning and maintenance of the motot unit
• Always remove the plug from mains before
cleaning the appliance.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water and a mild detergent).
Cleaning and maintenance of the jar
• Pour luke warm water and a mild non foaming
detergent into the jar.
• Place the lid onto the jar.
• Place the jar on to the motor unit.
• Switch the motor unit on at full speed for 10-20
seconds.
• Switch off the motor unit.
• Remove the jar from the motor unit.
• Rinse the jar thoroughly with clean water.
• In case of residu stuck to the knife carefully
clean with a small knife or tweezers. Never
clean the knife with your bare hands.
Troubleshooting
If the appliance does not function properly,
please check the below table for the solution. If
Problem
Appliance doesn't work
Appliance makes a strange
noise
Appliance emits an odd smell
The jar leaks or is otherwise
damaged
Extreme vibrations
Appliance doesn't cut evenly
The appliance only works when
puls switch is used
• Never use aggressive cleaning agents and/or
abrasives. Do not use any sharp and/or pointed
objects. Do not use petrol or solvents! Clean
with a damp cloth and mild detergent if neces-
sary. Do not use abrasive materials.
• Dry the in- and outside of the jar.
• After cleaning disinfect the jar. Use the in-
structions of the disinfectant manufacturer.
• Store the jar upside down.
• The underside of the jar may never come into
contact with any fluid!
• WARNING: Never disassamble parts of the jar
and cutting unit.
• WARNING: Never clean any parts of the appli-
ance in the dishwasher.
you are still unable to solve the problem, please
contact the supplier/service provider.
Cause
No power
Knife has been jammed
Appliance overheated
The jar is not placed on the
motor unit
Motor worn out or jar damaged Contact your supplier.
Motor unit burnt
Worn out cutting unit
Worn out motor unit or jar
The knife is damaged
Power module is defective
Solution
Check if the plug is connected
to mains.
Push the reset button on the
underside of the motor unit.
Remove the plug from mains
and let the appliance cool down
Switch the appliance of and
place the jar on the motor unit
and try again
Contact your supplier.
Contact your supplier or re-
place the jar with replacement
set 933668.
Contact your supplier or re-
place the jar with replacement
set 933668.
Contact your supplier or re-
place the jar with replacement
set 933668.
Contact your supplier
EN
7