In case of failure, loss, delay or error in the transmission of data that are beyond its control, if data did not reach it, for any reason, or if the data it receives were

illegible or impossible to process; in case the user was unable to access or use the application and associated services for any reason, the connection should

be suspended or interrupted.

Furthermore, Brandt declines all responsibility in case of misuse of the terminal and/or any incident related to the use of the terminal during the application.

Brandt can in no way be held responsible for any damage of any kind whatsoever caused to your terminal and the data stored on it, nor for the consequences

that may result from it.

* For security reasons, each appliance can only be connected to one user account. Consequently, in the case of a change of user of the device (transfer of the

device for example) the former user must delete his user account from his mobile application. The new user must ensure that the deletion has been completed

before he can create his own account by following the same installation and registration steps described in this manual.

However, the same user account can be used on multiple mobile phones or tablets. Therefore, in the case of a change of user of the device (e.g. transfer of

the device) the former user must delete his user account from his mobile or tablet application.

Note :

The previous day's display (see Settings menu): After 90 seconds of inactivity the dis-

play goes off, the Wifi connection is still active.

Council

If wifi is enabled you can use the Skip Smart Control function. In standby mode with

maintained network connection the device consumes at most 2W.

- Re-pairing the product .

1- Reset the product, Oven settings menu then Wifi then

Reset:( see Settings Menu).

2- Smartphone application, see Menu then Product management

then Reconnect the product.