Installation And Commissioning; Ambient Conditions; Electrical Requirements; Media Connections - SciCan STATMATIC PLUS 32 Gebrauchsanweisung

2 Installation and Commissioning

2Installation and Commissioning

Ambient conditions

The performance of the product is influenced by external factors!
Choose the appropriate location, taking the following influence factors into account.

Temperature and
air humidity
Environment
Work surface
Electromagnetic
environment
Pos: 19 /926-SycoTec/2_Installation und Inbetriebnahme_Statmatic Plus/2_Elektrische Anforderungen (Statmatic Plus) @ 9\mod_1378815285124_6.doc @ 84505 @ 2 @ 1

Electrical requirements

DANGER! Mortal danger with improper handling of power sources!
Danger of electrical shock.
Do not use multiple sockets.

When using power bars with surge protection, always only connect one device.

Use the power input plug on the side of the device as a separator from the power supply.

Pos: 20 /926-SycoTec/2_Installation und Inbetriebnahme_Statmatic Plus/3_Medienanschlüsse (Statmatic Plus) @ 9\mod_1378815433170_6.doc @ 84526 @ 2 @ 1

Media connections

Only use compressed air in accordance with the information provided in the technical data in order to ensure the

safe and trouble-free function of the device.
1. Plug the mains plug into the socket.
2. Attach the compressed air hose to the coupling and tighten.
3. Test the compressed air at the manometer.
The manometer indicates 4.3 – 4.5 bar.
– In the event of a deviating display, pull out the grip for regulating pressure and turn it to the right or the left until
the correct compressed air is displayed.
– Press the grip for regulating pressure back in and secure.
Pos: 21 /926-SycoTec/2_Installation und Inbetriebnahme_Statmatic Plus/4_Inbetriebnahme (Statmatic Plus) @ 8\mod_1346081395648_6.doc @ 69096 @ 2333 @ 1
Page 30
The recommended operating temperature lies between 5 °C and 35 °C with air humidity
between 25 % and 85 %.
Do not set up the product exposed to direct sunlight or near a heat source (e.g.

heater).
Operate the product in a clean, dust-free environment.

Set up the product on a flat, level, water-repellent and oil-resistant surface.

Under no circumstances install or operate the product on an inclined surface.

The product has been tested for electromagnetic emissions and meets the decisive standards.
While the product itself emits no radiation, it can be influenced by other radiating devices.
Keep the product at a distance from potential sources of interference.

STATMATIC PLUS 32 / 33 EN