Connecting The Power Cord; Preparing The Remote Control Unit; Installing The Batteries; Remote Control Operation Range - Sharp PN455RU Bedienungsanleitung

Connecting the Power Cord

Caution
• Do not use a power cord other than the one supplied with
the monitor.
1. Turn off the main power switch.
2. Plug the power cord (supplied) into the AC input terminal.
3. Plug the power cord (supplied) into the AC power outlet.
Main power switch
1
AC input terminal

Preparing the Remote Control Unit

Installing the batteries

1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (R-6 ("AA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
TIPS
• The supplied batteries (R-6 ("AA" size) x 2) may become
exhausted faster depending on the storage condition. It is
recommended that you replace them with new batteries
(commercially available) earlier than specified.
• If you will not use the remote control for a long time,
remove the batteries.
• Use manganese or alkaline batteries only.
12
E
3
For power
outlet
2
Power cord (Supplied)

Remote control operation range

The operation range of the remote control unit is approx. 16.4
feet (5 m) at an angle of approx 10° from the center to the
top/bottom/right/left of the remote control sensor.
16.4 feet (5 m)
16.4 feet (5 m)
10°
10°
TIPS
• Do not expose the remote control unit to shock by dropping
or stepping on it. This could lead to a malfunction.
• Do not expose the remote control unit to liquids, and do not
place it in an area with high humidity.
• The remote control unit may not work properly if the remote
control sensor is under direct sunlight or strong lighting.
• Objects between the remote control unit and the remote
control sensor may prevent proper operation.
• Replace the batteries when they run low as this may
shorten the remote control's operation range.
• If a fluorescent light is illuminated near the remote control
unit, it may interfere with proper operation.
• Do not use it with the remote control of other equipment
such as air conditioner, stereo components, etc.
Remote control sensor