Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STAND ALONE-MODE
Chaser
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
LED Bar 24/6 TCL, you can select up to 14 different chasers.
Selecting a chaser
Press the SET UP button. Select the desired chaser (00 – 14) via the UP or DOWN buttons
Select the desired chaser value via the UP or DOWN buttons. . (Step Time/Sp oder Flash Speed/Fs)
Fs (Flash Speed) from 00 to 100%.
Sp (Step Time) from 001 to 100 times/minute.
The desired values can be selected via the UP or DOWN buttons.
AUTO MODE
In Auto Mode the chasers are called up automatically in a continuous loop.
The desired frequency of the loops can be selected via the UP or DOWN buttons.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED Bar 24/6 TCL will respond to the controller.
Addressing
Press the SET UP button until the display shows DMX MODE dmx address:001.
Set the desired address via the UP or DOWN buttons.
Controlling:
After having addressed the LED Bar 24/6 TCL, you may now start operating it via your lighting controller.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX Channel Selection : Choosing a DMX Channel Mode in 20 Channal Occupation
Press the SET UP button until the channel modes appear on the LCD display. (channel num: 20, channel
num: 11, channel num: 8, channel num: 5)
Set the desired mode via the UP or DOWN buttons.
If the DMX value is less than 251, then the Dimmer occupies the first channel and the Flash occupies the
second channel.
20-Channel Mode:
Every spot occupies 3 channels.
Six spots occupy 18 channels.
The device occupies 20 channels.
20/43
00046604.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
