Makita HW001G Betriebsanleitung Seite 13

High pressure hoses, fittings and couplings are important for the
•
safety of the machine. Use only hoses, fittings and couplings
recommended by the manufacturer.
To ensure machine safety, use only original spare parts from the
•
manufacturer or approved by the manufacturer.
Always be sure that the machine is switched off and battery car-
•
tridges are removed before carrying out any work on the tool.
Do not use the machine if important parts of the machine are
•
damaged, e.g. safety devices, high pressure hoses, trigger gun.
Always remove the battery cartridges when leaving the machine
•
unattended.
Comply with the requirements of the local water supply
•
company.
For European countries:
•
According to EN12729 (BA), the appliance can also be con-
nected to the mains drinking water supply if a backflow preventer
valve with drain facility is installed in the supply hose.
SPECIFICATIONS
Model:
Max. flow rate *1
Water flow rate *2
Max. permissible pressure
Working pressure *2
Max. feed pressure
Max. feed temperature
Max. suction height
Rated voltage
Dimensions (L x W x H) *3
Net weight
Water protection
*1: When using the trigger gun without the nozzles.
*2: When using the vario spray nozzle and extension.
*3: When the handle is folded and without hoses.
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Mode 3 (High mode)
Mode 2 (Middle mode)
Mode 1 (Low mode)
Mode 3 (High mode)
Mode 2 (Middle mode)
Mode 1 (Low mode)
344 mm x 383 mm x 520 mm
13 ENGLISH
HW001G
7.0 L/min
5.5 L/min
4.2 L/min
3.0 L/min
11.5 MPa
8.5 MPa
5.5 MPa
3.0 MPa
1.0 MPa
40 °C
1.0 m
D.C. 36 V - 40 V max
10.3 - 13.4 kg
IPX5