Candy FIDC N200 Bedienungsanleitung Seite 4

to the current safety legislation the oven must be connect-
ed only placing an omnipolar breaker, with contact separation
compliant to the requirements for overvoltage category III,
between the appliance and the power source. The omnipolar
breaker must bear the maximum connected load and must be
in line with current legislation. The yellow-green earth cable
should not be interrupted by the breaker. The omnipolar break-
er used for the connection must be easily accessible when the
appliance is installed. The connection to the power source
must be carried out by a suitably qualified professional con-
sidering the polarity of the oven and of the power source. The
disconnection must be achieved incorporating a switch in the
fixed wiring in accordance with the wiring rules
• IF THE OVEN IS PROVIDED BY THE MANUFACTURER WITH
PLUG:The socket must be suitable for the load indicated on the
tag and must have ground contact connected and in operation.
The earth conductor is yellow-green in colour. This operation
should be carried out by a suitably qualified professional. ln case
of incompatibility between the socket and the appliance plug,
ask a qualified electrician to substitute the socket with another
suitable type. The plug and the socket must be conformed to
the current norms of the installation country. Connection to the
power source can also be made by placing an omnipolar break-
er, with contact separation compliant to the requirements for
overvoltage category III, between the appliance and the pow-
er source that can bear the maximum connected load and that
is in line with current legislation. The yellow-green earth cable
should not be interrupted by the breaker. The socket or omnip-
olar breaker used for the connection should be easily accessi-
ble when the appliance is installed. The disconnection may be
achieved by having the plug accessible or by incorporating a
switch in the fixed wiring in accordance with the wiring rules.
If the oven is with electromechanic control of temperature can
be used:- Connect a plug to the supply cable that is able to bear
EN 4