Troubleshooting; Spare Parts List Content; Possible Cause - FMS 1700mm Corsair F4U V3 Bedienungsanleitung

Trouble shooting
Problem
Aircraft will not respond to
the throttlebut responds to
other controls.
Extra propeller noise or
extra vibration.
Reduced flight time or
aircraft underpowered.
Control surface does not
move, or is slow to respond
to control inputs.
Controls reversed.
-Motor loses power
-Motor power pulses then
motor loses power.
LED on receiver flashes
slowly.

Spare parts list content

FMSEF101 Fuselage
FMSEF102 Main wing set
FMSEF103 Horizontal Stabilizer
FMSEF104 Rudder
FMSEF105 Battery Hatch
FMSEF106 Plastic Canopy
FMSEF107 Oil tank
FMSEF108 Rocket set
FMSEF109 Cowl
FMSEF110 Antenna set
FMSEF111 Pitot Tube
FMSEF112 Main wing bolt plate
FMSEF113 Rear landing gear hatch cover
FMSEF114 Front landing gear hatch cover
FMSEF115 Rear landing gear system
FMSEF116 Front landing gear system
FMSEF117 Front landing gear set
FMSEF118 Linkage rod
FMSEF119 Spinner
Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the
stock ESC instruction manual.

Possible Cause

-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low Voltage
Cutoff(LVC).
Power loss to receiver.
-Lower throttle stick and throttle trim to lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter, propeller and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight battery
instructions.
-Replace or repair damaged parts and adjust controls.
-Do a check of connections for loose wiring.
Do the control direction test and adjust controls for
aircraft and transmitter.
-Do a check of batteries, transmitter, receiver, ESC, motor
and wiring for damage(replace as needed).
-Land aircraft immediately and recharge flight battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
FMSEF120
FMSEF121
FMSEF122
FMSEF123
FMSEF124
FMSPROP062
FMSBM033
FMSDJ016
FMSDZ001
FMSKV300
PRESC023
FMS9GDP
FMS9GDR
FMS17GDP
FMS17MGDP
FMSRE058
FMSRE059
FMSSEQ6S
FMSCON015
12
Solution
Screw set
Sticker
Pipe set
LED set
Lamp Cover
18 X 11 Propeller(4-blade)
Motor Board
Motor Mount
Motor Shaft
Brushless motor 5060-KV300
80A ESC
9g digital gear servo positive
9g digital gear servo reverse
17g digital gear servo positive
17g digital metal gear servo
EL retract set
EL retract
Sequencer-6 sec
Multi Connector System
E
N