Black+Decker RVA425B Bersetzung Der Ursprünglichen Bedienungsanleitung Seite 10

ENGLISH
Error Display
NOTE: If there is hair wrapped around the side brush, you
may need to uninstall and reinstall the side brush.
Error Display
10
(Original instructions)
Error Code C:
Right hand side flashing
Red to OFF.
Problem:
Right wheel stuck.
Solution:
Clear debris/obstruction
from right wheel. Press
the power button twice
to clear the error and
restart the vacuum.
Error Display
Error code D:
2 front sections flashing
Red to OFF.
Problem:
Side brush stuck.
Solution:
Clear debris/obstruction
from side brush. Press
the power button twice
to clear the error and
restart the vacuum.
Error code E:
All LEDs Spinning
Pattern - Orange to
OFF.
Problem:
Dust Bin not fully
inserted.
Solution:
Press down on the
dustbin to fully install
into vacuum. Press the
power button twice to
clear the error and
restart the vacuum.
Error Display
To clear an error
After debris/obstruction has been removed from the
u
vacuum, clear the error by pressing the Start/Stop
button (3).
To resume vacuuming, press the Start/Stop button ( 3 )
u
again.
Troubleshooting
Problem Possible Cause
Vacuum stops Vacuum is in error
cleaning state.
Vacuum has
completed Quick
Clean or Spot
mode.
Battery charge is
low.
Vacuum does Charger is not
not charge. plugged in
correctly.
Power switch on
vacuum is not ON
Vacuum only Floor has dark
moves stripes or spots that
backwards or the vacuum detects
moves a few as a drop off or
inches before stairs.
backing up and Sensors are dirty.
stopping.
Vacuum keeps A wheel is blocked.
moving in small Vacuum is
circle. operating in SPOT
mode.
Vacuum does Sensors are
not detect drop covered.
off or stairs.
Error code F:
Front center LED
section flashing Blue to
OFF.
Problem:
Unit shut down, battery
level too low to return to
charging dock
automatically.
Solution:
Manually return robot to
charging dock. Press
the power button twice
to clear the error and
restart the vacuum.
Possible Solution
Clear error (see error indication
table pg 9 - 10) .
Charge battery.
Ensure the charger is fully plugged
into and the jack plug is properly
plugged into the vacuum or
charging dock.
Ensure power switch is "ON".
Only use vaccum on recommended
surfaces (pg 7).
Clean sensors with dry cloth.
Remove debris from blocked wheel.
Clean sensors with dry cloth.