Inhaltsverzeichnis
Werbung
OPTIONS AND FUNCTIONS
OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL).
If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED flashes rapidly 3 times
and beeps will sound. The option will not be enabled.
MULTIZONE
If there are not many dishes to be washed, a half loading may
be used in order to save water, electricity and detergent.
Select the program and then press the MULTIZONE button:
the indicator over the button lights up and the symbol of the
chosen rack will appear on the display. By default the appliance
washes dishes in all racks.
To wash only the specific rack, press this button repeatedly:
shown on the display (only lower rack)
shown on the display (only upper rack)
shown on the display (option is OFF and the appliance will
wash dishes in all racks).
Remember to load the upper or lower rack only, and to
reduce the amount of detergent accordingly.
If upper rack is removed, please apply detergent directly
to tub instead of detergent dispenser.
TABLET (Tab)
This setting allows you to optimize the performance of the
program according to the type of detergent used.
A long press (for 3 seconds) of the MULTIZONE button (the
corresponding symbol will light up), will activate the function
if you use combined detergents in tablet form (rinse aid, salt
and detergent in 1 dose).
If you use powder or liquid detergent, this option should
be off.
WATER TAP CLOSED – Alarm
Flashes when there is no inlet water or water tap is closed.
PUSH & GO
Push&Go button is an easily distinguishable button that allows
you direct access to the Push&Go program, a wash and dry cycle
that ensures great cleaning performance in a short time. You
don't have to worry which program to choose, Push&Go cycle
will do the work for you.
To select Push&Go program, switch on appliance, press only
Push&Go button for 3 seconds.
DELAY
The start of the program may be delayed for a period of time
between 0:30 and 24 hours.
1. Select the program and any desired options. Press the
DELAY button (repeatedly) to delay the start of the program.
Adjustable from 0:30 to 24 hours. With each press of the
button, the delay start increases by: 0:30 if selection below
4 hours, 1:00 if selection is below 12 hours, 4 hours if
selection is above 12 hours. If 24 hours reached, and the
button is pressed, the delayed start is deactivated.
2. Press the START/PAUSE button: the timer will begin counting
down;
3. Once this time has elapsed, the indicator light switches off
and the program begins automatically.
If at the time of the countdown the START/PAUSE button is
pressed again the DELAY option is cancelled and the selected
program starts automatically.
The DELAY function cannot be set once a program has
been started.
4
DRAIN OUT
To stop and cancel the active cycle, the Drain Out function
can be used.
A long press of START/PAUSE button, will activate the DRAIN
OUT function. The active program will be stopped and the water
in the dishwasher will be drained out.
EXTRA
EXTRA makes it possible to carry out a heavy-duty wash cycle
of large crockery up to a max height of 53cm: baking pans,
oven grids, dripping pans, hob grids, large saucepans, serving
dishes, pizza dishes, stainless-steel hood filters.
Remove the upper rack to load bulky crockery.
Release the two locks (right and
left) and pull out the rack.
When the upper rack is fitted, the
locks must be always closed.
In order for the water to reach the
crockery everywhere, arrange it as
shown in the Figure.
Do not start the dishwasher
without the upper rack using
wash cycles other than EXTRA.
To carry out the wash cycle Extra
pour the detergent DIRECTLY
INTO THE TUB and not into the
dispenser.
Auto Door
Auto Door is a convection drying system which automatically
opens the door during/after drying phase to ensure exceptional
drying performance every day. Door opens at the temperature
that is safe to your kitchen furniture.
As additional steam protection, special designed protection
foil is added together with the dishwasher (depending on the
model type - can be the need to buy it). To see how to mount
protection foil please refer to (INSTALLATION GUIDE).
Auto Door functionality could be disabled by the user as follows:
• To DISABLE: Switch On, then switch Off. Keep the P button
pressed for 5 sec., at the end of 5 sec the dishwasher plays a
short beep. Switch On the machine, the display shows „oOF".
• To ENABLE: Switch On, then switch Off the machine. Keep
the P button pressed for 5 sec., at the end of 5 sec the
dishwasher plays a short beep. Switch On the machine, the
display shows „oOn".
Werbung
Inhaltsverzeichnis
