Disposal; 15 Troubleshooting - Zipper Maschinen ZI-BHS2600 Betriebsanleitung

Improper storage can damage and destroy important components. Only store packed or al-
ready unpacked parts under the intended ambient conditions!
14.4

Disposal

Do not dispose of your machine in residual waste. Contact your local authorities for infor-
mation on available disposal options. If you buy a new vibratory plate or equivalent from your
dealer, he is obliged in certain countries to dispose of your old machine properly. If you pur-
chase a new machine or equivalent equipment from your specialist dealer, he is obliged in
certain countries to dispose of your old machine properly.

15 TROUBLESHOOTING

Hot surfaces and rotating machine parts while the engine is running can cause serious
injury or even death. Always switch off the machine before carrying out troubleshooting
work and secure it against unintentional restarting.
If you are unable to carry out the necessary repairs properly and/or do not have the required training, always
consult a specialist to solve the problem.
Trouble
Engine stalls, is diffi-
cult to start, or does
not start
The engine starts but
stalls or does not ac-
celerate properly
Engine does not start
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
WAR N I N G
Possible cause
Fuel filter blocked
•
• Fuel supply blocked
• Carburettor
Incorrect mixing ratio (petrol: 2-stroke oil)
•
• ON-OFF switch is in position „0" (OFF)
• Electrical problem
• ON-OFF switch is blocked
• Electrode gap of the spark plug
• Electrodes of the spark plug contaminated
• Electrodes of the spark plug contaminated
with fuel
Defective spark plug
•
Air filter dirty or worn
•
Fuel filter dirty
•
Fuel vent blocked
•
• Spark plug dirty or worn
• Carburettor
• Cooling system: Excessive and prolonged
operation in dirty or dusty areas.
Spark suppressor cracked or contaminated
•
Choke closed
•
• Internal engine problem
N O TE
TROUBLESHOOTING
Solution
• Clean or change
• Clean
• Contact the service team
• Use correct mixing ratio
• Clean or change the air filter
• Contact the service team
• Set the ON-OFF switch to position
"I" (ON).
• Contact the service team
• Contact the service team
• Check the electrode gap. This
should be between 0.6 - 0.7 mm.
• Clean or change
• Clean or change
• Change
• Clean or change
• Change
• Clean or change
• Clean, adjust or change
• Contact the service team
• Clean
• Replace
• Open Choke
• Contact the service team
31
ZI-BHS2600