Maintenance Plan; Clean Air Filter - Zipper Maschinen ZI-BHS2600 Betriebsanleitung

14.2.1

Maintenance plan

The type and degree of machine wear depends to a large extent on the operating conditions. The following
intervals apply when the machine is used within the technical limits:
Components Action
Throttle trigger
and throttle trig- Check function
ger lockout
ON-OFF switch Check function
Check: Blades must
not move when the
engine is idling and
Blade bar
with the choke is
closed
Check for firmness
Screws and nuts and tighten if neces-
sary
Engine, fuel tank
Check for leaks
and fuel line
Check for damage, re-
Blades
place if necessary
Check for damage /
Blade guard deformation and re-
place if necessary
Machine Clean outside
Starter handle and
Check for damage
start rope
Cooling system Clean
Clean,
Check electrode gap,
Check that the spark
Spark plug
plug cap is in place
Replace,
Check that the spark
plug cap is in place
Fuel tank Clean
Cables and con-
Check
nections
Gear box Grease
Clean, replace if nec-
Air filter
essary
Fuel tank and filter Clean
Check, replace if nec-
Fuel feed line
essary
(1) Maintenance must be carried out more frequently when operated in dusty areas.
(2) Only a specialist should carry out this maintenance!
14.2.2

Clean air filter

NOTE:
Never operate the machine without air filter!
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Before
usage
x
x
x
.
x
x
x
x
x
• Loosen the wing nut (2) on the air filter housing and remove
the air filter cover (1).
• Take out the air filter (3).
• Clean the air filter (3) with soapy water, then rinse with clear
water and let it dry thoroughly before reassembling.
NOTE:
Never use petrol or combustible solvents to clean the air
filter (risk of fire and explosion).
• The reassembly is done in reverse order.
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
After us- Weekly Monthly or
age every 25
operation
hours
x
x
x
x
Every three years (2)
Every 3 Every 6
months or months
every 50 or every
operation 100 oper-
hours ation
hours
x
x
x
x
x (1)
x (1)
x (2)
29
ZI-BHS2600