14.2.3
Spark plug
14.2.4
Blade bar: clean and lubricate
14.2.5
Lubricate the gear box
Lubricate the gearbox every 10-20 operating hours.
14.3
Storage
Observe all safety precautions for the safe storage and handling of fuel/gasoline.
Store the machine in a dry, frost-proof and lockable place when not in use. Make sure that unauthorised
persons and especially children do not have access to the machine.
•
Clean the machine properly and apply anti-corrosion grease to the blade bar.
Please note that the fuel tank must be drained before storing the machine. To do this, proceed as follows:
•
Place the machine onto a flat, solid surface.
•
Unscrew the fuel filler cap and drain the fuel into a container approved for fuel.
•
Press the intake pump several times until fuel begins to empty the bulb.
Then drain the remaining fuel into the container.
•
Screw the fuel filler cap back on.
•
ZIPPER MASCHINEN GmbH
www.zipper-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
• Remove the spark plug cover.
• Remove the spark plug cap.
• Clean any dirt from around the spark plug base.
• Loosen the spark plug using the spark plug spanner.
• Visually inspect the spark plug and remove carbon deposits
with a copper wire brush.
• Pay attention to discolouration on the top of the spark plug.
The standard colour is tan.
• Check electrode gap. This should be between 0,6 -0,7mm.
• If necessary, change the spark plug.
• Screw in the spark plug the first few turns by hand.
• If it is tight, tighten the spark plug with the
.
wrench
• Refit spark plug cap and then reinstall the spark plug cover.
• Clean the blades from resin and plant residues with a clean-
ing agent before and after operating the machine.
• Before longer storage, apply anti-corrosion grease to the
blade bar.
• Place the grease gun onto the lubrication nozzle (1).
• Press some grease into the lubricating nozzle.
• Use a multi-purpose grease of class NLGI 2 or an equivalent
product.
WAR N I N G
spark plug
30
ZI-BHS2600