Configuration Via The Wired Wall Thermostat - HomeMatic IP HmIPW-FAL230-C6 Installations- Und Bedienungsanleitung

If connecting was successful, the LED (A) lights
•
up green. The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate
it to a room.
If you are already using Homematic IP devices in
your smart home system or if you want to com-
bine your Homematic IP Wired devices with wire-
less Homematic IP components, you can also
connect the Homematic IP Wired devices to an
(installed) Access Point. Therefore, connect the
Homematic IP Wired Access Point to the (already
installed) Homematic IP Access Point, as de-
scribed in the user manual. Afterwards, please
proceed as described above to connect the floor
heating actuator.
7 Configuration via the Wired Wall
Thermostat
The Homematic IP Wired Floor Heating Actuator
can be configured via the Homematic IP Wired
Wall Thermostat (HmIPW-WTH), via the Home-
matic IP Wired Access Point together with the
smartphone app or via the WebUI of the CCU3.

Configuration via the Wired Wall Thermostat

71