Introduction; Classification - Frank bSteam bS35 VAC Betriebsanleitung

The text has been carefully checked; however, if there are any typographical errors
we ask you to inform the manufacturer of these. We reserve the right
right to change this publication at any time without prior notice,
to improve the product.
This manual may not be reproduced in whole or in part without the consent of the
manufacturer.
The most important instructions are indicated by the symbol.

1. Introduction

Before installing, starting up and using the device, please read these
use of the device, please read these instructions, which are part of the
of the product.
Please read the information and instructions in this manual carefully as
carefully as they contain important information about safety and
maintenance. Particularly important are the general instructions for
use.
Keep this manual in a safe place for future reference. to be able to
refer to it at any time. Steam generators are manufactured in
accordance with the are manufactured in accordance with the
regulations in force. The user of the appliance must be familiar with
the contents of these instructions for use.

2. Classification

The user must observe the conditions of use prescribed by standards; in particular, he
must comply with the following classification: The steam vacuum cleaner complies with
protection class I for protection against electric shock.
Always contact your dealer or service centre to replace the thermal cut-out.
The steam vacuum cleaner is adjusted at the factory and all safety devices contained
therein are sealed.
It is forbidden to change the setting of these devices.
The steam vacuum cleaner may only be used on a firm and level floor. Failure to
observe this instruction may result in danger.
The steam vacuum cleaner must not be used in a corrosive or potentially explosive
atmosphere (vapours, gas).
The electrical connection must comply with the applicable standards and the
manufacturer's instructions.
Check that the electrical power of the installation and the sockets corresponds to the
maximum power of the appliance indicated in W on the nameplate. If in doubt, consult
a technician. Have a suitable plug fitted only by a qualified electrician.
2