Frank bSteam bS108 VAC Betriebsanleitung Seite 33

1- Turn on the machine and wait for the pump to fill the boiler. (It may happen that
during the first charging cycle the "End of water" light comes on and you have
to shut down/restart the machine to finish the charge). When fully charged, the
machine will start the heating cycle (Heat): do not wait for the heating to start,
but immediately turn off the main switch, turn off the main switch, unplug the
machine and let it rest for 6-7 hours.
(Attention: do not allow within the solution over the specified period).
2- With the appliance cold and the plug unscrewed, shake well and then open the
cap under the boiler (15), now empty well all the limestone dissolved in the
solution. Carefully clean and close the drain plug.
3- Fill the tank (7) with clean water. Switch on the appliance and wait until the
boiler is recharged and follow the instructions under " USE ". Wait for the
charging process and the heating. Now the steam supply smells of lemon for
about 10 minutes, given by the wash performed.
► After cleaning the boiler, it is advisable to check whether the Caps under the
appliance are leaking. In this case, check their closure with a wrench or replace
the seal after the machine has cooled down. machine has cooled down.
15