Frank bSteam bS108 VAC Betriebsanleitung Seite 27

To release steam with the handle on the hose once the machine is ready for use, press
the lever (10). Now use the brush or accessories for the surfaces to be cleaned.
Caution: It is recommended that the first steam release after heating be
performed over a container for approximately 1 over a container
for about 1 minute to catch any condensation that may to collect
any condensation generated in the initial cold channels. generated.
Attention: when working on sensitive surfaces or objects
work, keep the steam jet at a distance of at least
sufficient distance of at least 20-40cm.
Detergent use or hydrojet:
If you want to use detergent, check and fill the tank (8), turn on the function by
pressing the button (3a) on the front panel (CHEM), keep it pressed to regulate the
intensity. If you want to use Hydrojet, activate the function by pressing the button (3)
on the front panel (HJET), keep it pressed to regulate the intensity. Now press the
button (12) on the handle to start draining detergent/hydrojet onto the surface to be
cleaned. To stop it, press again the button
(3 - 3a) (Chem. Off / Hjet OFF).
Translated with www.DeepL.com/Translator (free version)
Vacuum Use:
Before vacuuming, remove the dirty water tank (9a) and check that the filter is
inserted. Check whether the switch (9) is switched on. Now press the button (11) and
you can vacuum dirt and liquid (the display shows "MAH" to indicate activation of the
maximum suction power).
When the dirty water tank (9a) is filled with dirty water, the vacuum sound changes
and then stops; stop the machine immediately and empty the dirty water tank. When
vacuuming is performed, it is advisable to clean the filter regularly and dry the bucket
or leave it open to dry.
Regulation of the steam outlet:
Use the adjustment knob (4) on the front of the unit to gradually adjust the steam
output.
End of water:
The acoustic and visual message of the display (2) indicates with "-H2O" that there is
no more water in the tank. The machine therefore stops the steam discharge.
9